- DJI LIGHTBRIDGE VIDEO DOWNLINK PATCH
- DJI LIGHTBRIDGE VIDEO DOWNLINK FULL
- DJI LIGHTBRIDGE VIDEO DOWNLINK ANDROID
- DJI LIGHTBRIDGE VIDEO DOWNLINK SOFTWARE
Encryption can be set up through the Lightbridge app.ĭJI Lightbridge 2.4G full HD digital video downlink price adjustment announcementĪs the DJI Lightbridge 2.4 G full HD digital video downlink has been delayed for some time, DJI has lowered its price to make up for the long wait. One ground system will send the control signal while additional ground systems receive the video signalĮncryption ensures that only authorized devices receive data. Each can work independently without interference with proper distance between them.Ī single air system can transmit to multiple ground systems, sending video to multiple screens. Up to 8 downlinks can be connected for parallel streaming. OSD is available natively, no additional equipment required.
DJI LIGHTBRIDGE VIDEO DOWNLINK ANDROID
Extreme internal and external shielding for interference protection. Also functions as a USB charger for mobile devices prolonging the life of peripheral equipment.Įlectromagnetic Interference Shielded Structural Design Rechargeable through the supplied charger or via a 3S~6S Li-Po power battery.A full charge takes approximately 1.5 hours. Ground unit has a built in high capacity 4000mA battery offering up to 4.5hours of use per charge. Encryption ensures only authorized devices can receive data which can be programmed via mobile device software. (Only one of the ground units can send a control signal while additional ground units will only be able to receive a video signal) A single air unit can transmit to multiple ground units sending video to multiple screens. Multi-device Operation Mode, Stable and Reliable Phantom 2, with DJI 5.8G radio transmitter. DJI A2, WooKong-M and Naza-M V2 flight controllers Must Work With DJI Multi-Rotor Flight Controllers
DJI LIGHTBRIDGE VIDEO DOWNLINK SOFTWARE
OSD functionality can be turned off via mobile software for HDMI and iOS/Android Output. Flight parameters will be displayed onscreen. No additional equipment required for OSD functions when used with A2/WooKong-M/Naza-M V2 flight controllers.
Up to 8 downlinks can be connected for parallel streaming and work independently without interference.īuilt-in OSD (On-Screen Display) Function Channel interference is constantly monitored during downlink transmission with automatic switching between 8 channels for the best possible signal. MIMO multi-antenna technology and OFDM modulation methods along with advanced algorithms are utilized for downlink transmission to enhance data bandwidth, improving dynamic performance and increasing stability even in harsh environments. Frequency Hopping Spread Spectrum(FHSS) + Direct Sequence Spread System(DSSS) technology is used for uplink transmission to enhance stability and offer anti-jamming capability. The DJI 5.8G radio transmitter is recommended. When used with a non-2.4G radio transmitter, video only transmission operation is supported. Control signals are received in the air and then transmitted to the flight controller through D-BUS. Support for two remote controls: one for flight control (10 Channels) and the other for gimbal control (6 Channels). Remote control data travels to the uplink via the TX-Thru Port at the same time that video is streamed back down all without interference. Uplink remote control transmission and downlink video work simultaneously on 2.4GHz. USB 2.0 image data output for iOS and Android phones and tablet synchronization DJI Zenmuse gimbal input (Digital Video/Power Supply/OSD Data)
DJI LIGHTBRIDGE VIDEO DOWNLINK PATCH
Optional 14dBi patch antenna boosts transmission distance tremendously to 5km (3.1 miles) 5dBi omni-directional antenna offers an enormous distance of up to 1.7 km (1.05 miles) Less than 100mW ground unit transmission in full compliance with CE and FCC certification
0 kommentar(er)
